Overview of Setting Up Weather-Based Watering
Posted by Leanne Lloyd-Fairey on 07 March 2016 02:21 PM

If you are a new Baseline customer and you want to configure WeatherAccess™, Baseline's weather-based watering with the initial setup of your irrigation controller, you'll need to perform all the steps in the following list.

If you already have your Baseline irrigation controller set up and your BaseManager Plus account activated and configured, and you want to convert to WeatherAccess, you'll need to perform the steps in the following list starting at Step 9.

Step 1: Install your controller and connect all your devices (Refer to your controller's user manual)

Step 2: Make sure your controller is running the most current firmware version (Refer to your controller's user manual)

Step 3: Search for and assign devices (Refer to your controller's user manual)

Step 4: Set up basic programs (Refer to your controller's user manual)

Step 5: Install your communication equipment (Refer to the installation guide that came with your communication equipment)

Step 6: Connect your controller to BaseManager (Refer to the BaseManager Quick Start Guide)

Step 7: Call Baseline to activate your BaseManager Plus account (Call 866-294-5847)

Step 8: Set up your BaseManager Plus account (Refer to the topics under Setting Up Your BaseManager Account in the BaseManager online help)

Step 9: Connect a weather station to BaseManager

Step 10: Assign the weather station to your controller

Step 11: Configure the hydrozone settings

Step 12: Enable the controller to use WeatherAccess

(0 vote(s))
Not helpful