Using Quick View
Posted by Leanne Lloyd-Fairey on 31 December 2014 11:32 AM

The Quick View page summarizes the status of the controller, its assigned devices, programs, and any alarms and messages on a single page.

  1. Make sure that the controller that you want to see details for is displayed in the BaseManager footer. To select a different controller, click the Menu icon in the upper-left corner of the BaseManager page, and then click Sites and Controllers. Continue drilling down until you can select the desired controller.
  2. Click the Quick View tab. The Quick View page shows the Zone and Program Status, the messages, and the device details for the selected controller.
  3. You can perform the following tasks on the Quick View page:
    • Expand or Collapse a Section: Click the or the in the header of any section on the Quick View page to expand or collapse the section. When collapsed, the Zone Status and the Programs Status still show two grids.
    • View Zone or Program Status by Color: Check the Zone Status and Program Status grids on the left side of the page for colored squares that represent a specific status. The Status Color key is available from the menu.
    • View Zone or Program Status Details: In the Zone Status and Program Status grids on the left side of the page, click in the square for the specific zone or program that you want to see details for. The details display in a pop-up box. Click the X in the upper-right corner to close the box.
    • Manually Run a Zone, Program, or Master Valve: In the Zone Status, Program Status, or Master Valve Status grids on the left side of the page, click in the square for the specific zone, program, or master valve that you want to manually run. In the pop-up box, type a number in the Minutes field, and then click .
    • Set a Zone or Program to Done: In the Zone Status and Program Status grids on the left side of the page, click in the square for the specific zone or program that you want to stop. In the pop-up box, click .
    • Test a Zone or Master Valve: In the Zone Status or Master Valve grid on the left side of the page, click in the square for the specific zone or master valve that you want to test, and then click the Test icon . The test results display in the pop-up box.
    • Learn Flow for a Zone or Program: In the Zone Status and Program Status grids on the left side of the page, click in the square for the specific zone or program that you want to learn flow for. In the pop-up box, click .
    • View a Chart for a Zone or Program: In the Zone Status and Program Status grids on the left side of the page, click in the square for the specific zone or program that you want to view a chart for. In the pop-up box, click .
    • Edit a Zone, Program, or Master Valve: In the Zone Status, Program Status, or Master Valve Status grids on the left side of the page, click in the square for the specific zone, program, or master valve that you want to edit. In the pop-up box, click .
    • Sort the Message List: In the Messages section on the right side of the page, click on any of the column headers to sort the list in either ascending or descending order by the data in that column.
    • Delete a Message: In the Messages section on the right side of the page, click the X at the end of the row for the message that you want to delete.
    • Clear All Messages: In the Messages section on the right side of the page, click the Clear All Messages at the bottom of the section.
    • View Weather Station Information: If you have a weather station assigned to the controller, you can see the weather station description, the calculated ETo amount, and the date and time when the weather data was captured. For more detail, refer to Viewing Weather Station Information in Quick View.