Knowledgebase: Programming
BaseStation 3200 – Shutting Down Irrigation Based on a Water Source Empty Condition
Posted by Leanne Lloyd-Fairey on 05 March 2014 10:21 AM

With Baseline’s BaseStation 3200 irrigation controller, you can use water from multiple sources to run your irrigation programs. If one of the water sources has a limited supply, it’s important to monitor the quantity of water in order to avoid pumping the source dry.

If you have configured this reservoir as a specific water source, you can install an event biCoder with a float switch or a biSensor to monitor the water level and stop using that water source when the water drops below a specified level.

Find complete instructions for programming your BaseStation 3200 in the following PDF document:

Shutting Down Irrigation Based on a Water Source Empty Condition

(0 vote(s))
Helpful
Not helpful